DIGITAL TUNER
7
English
TUNING TO RADIO STATIONS
1.
Select
TUNER
source.
™
is displayed briefly and then the radio station
frequency is shown.
2.
Press
BAND
once or more to select your waveband.
3.
Press
SEARCH
∞
or
§
and release when the frequency in
the display changes.
™
The radio automatically tunes to a station of sufficient
reception. Display shows
during automatic tuning.
™
If a FM station is received in stereo,
STEREO
is shown.
4.
Repeat step
3
if necessary until you find the desired station.
• To tune to a weak station, press
SEARCH
∞
or
§
briefly and
repeatedly until you have found optimal reception.
5.
Adjust the power slider to
TAPE/OFF
position to switch off the
set.
To improve radio reception
– For
FM
, pull out the telescopic aerial. Incline and turn the
aerial. Reduce its length if the signal is too strong (very close
to a transmitter).
– For
MW
/
LW
, the set is provided with a built-in aerial so the
telescopic aerial is not needed. Direct the aerial by turning the
whole set.
Programming radio stations
You can store up to a total of 30 radio stations in the memory.
1.
Tune to your desired station (see
Tuning to radio stations
).
2.
Press
PROG
to activate programming.
– Display:
PROGRAM
flashes.
3.
Press
PRESET
4
or
3
once or more to allocate a number from
1 to 30 to this station.
4.
Press
PROG
again to confirm the setting.
– Display:
PROGRAM
disappears, the preset number and the
frequency of the preset station are shown.
5.
Repeat the above four steps to store other stations.
– You can overwrite a preset station by storing another
frequency in its place.
Tuning to preset stations
Press
PRESET
4
or
3
until the desired preset station is displayed.
AZ 1040/00
page
7
FM
STEREO
PROG
BATT
LOW
MODE
STOP
PLAY•PA
USE
SEARCH
TUNER
PROG
BATT
LOW
STOP
LAY•PA
USE
SEARCH
SHUFFLE
ALL
BAND
PRESET
DIGITAL
TUNER
PROG
BATT
LOW
OP
RECORD
AY
SHUFFLE
ALL
BAND
PRESET
DIGITAL
TUNER
