Philips AVENT SCD535, Руководство пользователя

Страница: 19 / 292

environment
- Do not throw away the appliance with the normal household waste at the end of its life, but
hand it in at an oficial collection point for recycling. By doing this, you help to preserve the
environment (Fig. 35).
- Non-rechargeable batteries and battery packs contain substances that may pollute the
environment. Do not throw away non-rechargeable batteries and battery packs with the normal
household waste, but hand them in at an oficial collection point. Always remove non-
rechargeable batteries and battery packs before you discard and hand in the appliance at an
oficial collection point. (Fig. 36)
guarantee and service
If you need service or information or if you have a problem, please visit the Philips AVENT website
at www.philips.com/welcome or contact the Philips Consumer Care Centre in your country (you
ind its phone number in the worldwide guarantee lealet). If there is no Consumer Care Centre in
your country, go to your local Philips dealer.
Frequently asked questions
This chapter lists the questions most frequently asked about the appliance. If you cannot ind the
answer to your question, contact the Consumer Care Centre in your country.
Question Answer
What is ECO mode?
How does this
mode help the
environment? The ECO mode has been developed to enable you to reduce your
energy consumption. Monitoring your baby from a small distance
requires less power than monitoring your baby from a large distance.
When you monitor your baby from a small distance, you can activate
the ECO mode. By switching on the ECO mode, your baby monitor
uses less energy and is therefore more enviornment-friendly.
Why don’t the
power-on light of the
baby unit and the LINK
light of the parent unit
come on when I press
the on/off buttons of
the units? Perhaps the rechargeable battery pack of the parent unit is empty and
the parent unit is not in the plugged-in charger. Insert the small
appliance plug into the charger, put the adapter of the charger in a wall
socket and place the parent unit in the charger. Then press the on/off
button to establish connection with the baby unit.
Perhaps the non-rechargeable batteries of the baby unit are empty and
the baby unit is not connected to the mains. Replace the non-
rechargeable batteries or connect the baby unit to the mains. Then
press the on/off button to establish connection with the parent unit.
If the LINK light on the parent unit still does not start to lash, use the
reset function to reset the units to their default settings.
Why does the LINK
light on the parent unit
light up red
continuously and why is
the message ‘Searching’
shown on the display? The baby unit and the parent unit are out of range of each other. Move
the parent unit closer to the baby unit.
The baby unit may be switched off. Switch on the baby unit.
ENGLISH
19