TUNING
Direct Access tuning
The frequency of the station you wish to tune to must be
known. You can find these frequencies in station tables or
radio guides.
1
In the radio mode, press
ENTER.
™
The current frequency in the display disappears.
2
Use the Preset memory buttons to enter the digits of your
desired frequency within a 5 second period.
3
Press
ENTER
again to confirm your radio station.
™
The display shows the selected frequency or the nearest
frequency.
™
If you have made an incorrect entry,
Err
will appear in
the display.
Entry examples of bands and frequencies:
e.g.i
98.1 MHz, FM
: Press
9,8,1
and
ENTER
e.g.ii
603 KHz, AM (MW):
Press
6,0,3
and
ENTER
Manual tuning
•
Press
TUNING –
or
+
briefly, once or as often as required
until the right frequency is found. In this way, the frequency
can be changed step by step.
Automatic tuning
1
Press and hold down the
TUNING –
or
+
control until the
display frequency starts to run.
2
When a station of sufficient strength has been found, tuning
will stop, or you can stop the automatic tuning by pressing
the
TUNING –
or
+
control again.
3
Repeat until you have found the desired station.
SELECTING & STORING FREQUENCIES: PRESETS
You can store the frequencies of 20 radio stations in the
memory, 10 on each waveband. A stored frequency is only
erased from the memory by storing another frequency in its
place, or if you reset your unit.
1
Select the waveband and tune to your desired station.
2
Select and press one of the Preset memory buttons
0-9
for
more than two seconds to store your station.
™
PRESET
and your selected number will appear in the display.
7
AQ 6688 /00 - page 7
RADIO RECEPTION
English
