3 - 2
Selecting a different track during playback
The track number appears briefly in the display when you
press
∞
or
§
to skip tracks.
•
Press
§
once or more to skip to the next track(s).
•
Press
∞
once and playback will return to the beginning
of the current track.
•
Press
∞
more than once to skip to previous tracks.
Finding a passage within a track
1.
During playback, press and hold down
∞
or
§
y
The CD is played at high speed and low
volume; the display will show '
Cd
:' and your
current track number
.
2.
Release
∞
or
§
when you recognize the passage you
want.
y
Normal CD playback and standby clock time resumes.
RADIO
1.
Press
RADIO ON (FM/ AM)
to switch on the radio.
y
Display shows '
tu
' before returning to clock time.
2.
Press
RADIO ON (FM/ AM)
again if you wish to
change waveband.
3.
Adjust the sound using
4
or
3
4.
Adjust the
TUNING
wheel to tune to a radio
station.
To improve reception:
FM:
Extend coil antenna at the back of the unit fully for
optimum reception.
AM:
Uses a built-in antenna. Direct the antenna by adjust-
ing the position of your set.
5.
Press
ALARM RESET
to switch off.
SETTING THE ALARM OPTIONS
GENERAL
Two different alarm times,
AL 1
and
AL 2
can be set in the
CD, radio or buzzer modes.
Selecting the Alarm Mode Options
When selected, the selected alarm mode is shown in the
display
, and the respective
AL 1
or
2
button lights up.
1.
Select your choice of alarm mode.
Either press briefly:
•
AL1
once for CD alarm
.
This enables CD
playback from the first track as your alarm call.
•
AL2
once or more for
radio
/
buzzer
alarm
2.
Read the following section if you want to select the
W
AKE-UP TRACK
alarm option.
Selecting CD W
AKE-UP Alarm Mode
You can program and select a CD track number between 1-
99, when the set is in the standby or radio playback mode.
However
, if the track number programmed does not exist on
your CD, the CD will start playback from the first track dur-
ing the alarm call.
1.
Set the alarm time for
AL1
.
2.
Insert a CD into the CD compartment.
3.
Press
AL 1
to select CD alarm mode.
4.
Press
W
AKE-UP TRACK
to activate favorite track pro
-
gramming.
5.
Press
∞
or
§
until the desired track number is shown.
6.
Press
W
AKE-UP TRACK
to confirm the selected track
number
.
y
The display returns to standby clock time.
7.
If you want to review your programmed track number
,
press
W
AKE-UP TRACK
Note:
•
The buzzer alarm option will automatically replace the CD
alarm if you have:
–
inserted a CD incorrectly;
–
inserted a damaged CD;
–
forgotten to insert any CD;
–
not closed the CD door properly
.
Gentle W
ake V
olume
A sure way of getting up in the mornings, the
gentle wake
volume for the alarm begins from a fixed gentle volume
(
10
) and gradually increases to a maximum higher setting
of (
25
.)
•
The default low volume is
Lo
:
10
, and the
maximum volume is
HI
:
25
.
•
During the alarm call, if you press
4
or
3
, the
volume stops increasing immediately
.
•
The gentle wake volume settings do not affect
nor
mal CD and radio playback volume level, unless you
have pressed
4
or
3
during the alarm call.
SWITCHING OFF THE ALARM
There are three ways to switch off the alarm. Unless you
cancel the alarm completely
, the
24 HOUR
ALARM
RESET
will be automatically selected after 59 minutes,
from the time your alarm time first goes off.
24 HOUR ALARM RESET
If you want the alarm mode to be stopped
immediately but also wish to retain the same alarm setting
for the following day:
•
Press
ALARM RESET
.
y
You will hear a beep tone to confirm the 24 hour
alarm is reset.
REPEA
T ALARM
This will repeat your alarm call at 9-minute intervals.
•
During the alarm call, press
REPEA
T ALARM/ BRIGHT-
NESS CONTROL
.
•
Repeat if desired up to an hour
.
Note:
•
The selected alarm mode
,
or
indicators flashes throughout the repeat alarm duration.
•
If you are using the CD alarm mode, CD playback
resumes at the point where the repeat alarm
interrupted.
•
During the CD alarm, CD playback continues for up to an
hour unless you cancel / reset the alarm.
CANCELING THE ALARM COMPLETEL
Y
To cancel the set alarm time before it goes off, or
during the alarm call:
•
Press
AL1
or
AL 2
once or more until the selected alarm
indicator disappears from the display
.
y
You will hear a beep tone to confirm the alarm has
been cancelled.
SLEEP
About Sleep
The CD clock radio has a built-in sleep timer which enables
the set to be automatically switched off
during radio or CD playback after a set period of time. There
are 3 sleep times: 60, 30 and 15 minutes.
The sleep function does not change the operation of your
alarm settings.
Setting SLEEP
1.
Press
2;
(CD) or
RADIO ON
(radio) to switch on the
desired mode.
•
You can also press
SLEEP
if you want the timer in radio
mode.
2.
Select your timer option by pressing
SLEEP
once or
more until the desired option is
shown.
•
Display shows
SL:
and the timer
options:
60
➟
30
➟
15
minutes
➟
60
➟
30
...
3.
To cancel the timer function you can either:
•
Press
ALARM RESET
.
•
Press
REPEA
T ALARM/ BRIGHTNESS CONTROL
.
•
Press
SLEEP
once or more until the sleep function is no
longer shown.
AL TIME 2
Radio Alarm:
If you have selected the radio alarm, make sure you
have tuned pr
operly to a station.
NSTRUCTIONS FOR USE
www.freeservicemanuals.info
10/11/2012
www.nostatech.nl
World of free manuals
