INSTALLATION
POWER SUPPLY
1
Check if the mains supply, as shown on the
type plate as shown inside the
battery compartment
, corresponds to your local mains supply. If it does not,
consult your dealer or service center.
2
Connect the mains cord to the wall socket.
3
To disconnect the set from the mains supply completely, remove the
plug from the wall socket.
CLOCK MEMORY BACKUP
The clock memory backup allows your alarm and clock time settings to be stored
for up to a day when there is a power interruption e.g. mains failure. The
complete clock radio and display illumination will be switched off. As soon as the
mains supply returns, the display will indicate the correct time.
1
Remove the battery door to insert a
9 volt 6F22
type battery (not included) for
backup.
2
Replace the battery door.
NOTE:
If no backup battery is installed or the power interruption is prolonged, you
will need to set the clock and alarm times again.
Batteries contain chemical substances so should be disposed of
properly.
Standby power consumption . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3W
ILLUMINATION BRIGHTNESS
Adjust the
BRIGHTNESS
switch to
HI
or
LOW
-
HI
to increase brightness
-
LOW
to select low illumination
