4 Use your TV
Switching on your TV and putting it in
Standby mode
Remote Control
TV
To Turn the TV On from Standby or Off to Standby
•
Press
B
on the Side panel or the Remote Control.
Note(s)
•
Energy Consumption contributes to air and water pollution. When the AC Power Cord is plugged
in, your TV consumes energy with a very low Standby Power Consumption.
Adjusting Volume
Remote Control
TV
To decrease or increase Volume
•
Press
VOL
J
/
K
on the Side panel or press
VOL + / –
on the Remote
Control.
VOL
J
(–) : Volume Down
VOL
K
(+) : Volume Up
To mute or unmute sound
•
Press
V
on the Remote Control to mute the sound.
•
Press
V
again or
VOL + / –
to recover the original sound.
Switching Channels
Remote Control
TV
To Select Channels by using CH
H
/
I
or CH + / –
•
Press
CH
H
(Up) /
I
(Down) on the side panel or press
CH + / –
on the
Remote Control.
To Select Channels by using the NUMBER buttons
Digital TV Operation
•
For Digital channels, press a number followed by a dot “
•
” and the
corresponding sub channel number.
–When selecting Digital channel 1 1. 1
Be sure to press
•
before entering the subchannel number.
Cable / NTSC (Analog) TV Operation
–When selecting Cable or Analog channel 1 1
Press
PREV.CH
to return to the previously viewed channel.
Note(s)
•
To Select the non-memorized channels, use
the NUMBER buttons
.
•
Channel not available
or
No signal
will appear on the TV screen after the subchannel broadcast
is over.
•
Audio only
message will appear on the TV screen, when you receive only sound signal.
20
.
English
Continued on next page.
