7
Press
OK
to finish
Settings assistant
.
Exit
Back
Store
You have set up your viewing preferences.
Settings assistant
•
When the initial setup is completed, the lowest memorized channel
with the confirmation message of the location setting will be
displayed on the TV screen.
•
You must set
Home
in step
4
. Otherwise,
Picture
and
Sound
settings you adjusted will not be memorized after the unit goes into
Standby mode.
Note(s)
•
If you are not receiving a signal from your Cable service, contact the Cable provider.
•
If you press
or
during Autoprogram, this Setup of TV channels will be Cancelled.
•
The Initial Autoprogram function can be executed for either
Antenna
or
Cable
only Once. When
you change the Connection (Antenna / Cable), select
Autoprogram
again.
p.
24
•
If there is no signal Input from the Antenna terminal and no operation for several seconds after
you Turn On the Unit, Helpful hints appears. Follow the instructions listed on the TV screen.
Skip
OK
Select
Later
Retry
Initial setup
####
####
the appropriate source input.
press "SOURCE" key on the remote control to select
the input which you have connected to the box and
If you are using a cable or satellite box, please confirm
installation process searches this connection.
ANTENNA IN jack on the back of the TV, the channel
Verify that you have a cable connected to the
Try Autoprogram again?
No channel is registered.
After an Initial Setup is completed...
•
If you want to scan the channels Automatically again.
Autoprogram
p.
24
•
You can add the desired Cable and Analog channels not memorized
by Autoprogram.
Add channels
p.
25
•
If you want to change to another Language.
Language
p.
31
•
If you want to change the Location setting.
Location
p.
30
•
If you want to restore the picture setting.
Settings assistant
p.
22
16
.
English