Mechanical Instructions
4.
Figure 4-15 Rear cover removal [2]
4.5.3
Small Signal Board (SSB)
Refer to
for details.
Caution:
it is mandatory to remount all different screws at their
original position during re-assembly. Failure to do so may result
in damaging the SSB.
1.
Release the clips from the LVDS connector that connect
with the SSB [1].
Caution:
be careful, as these are very fragile connectors!
2.
Unplug all other connectors [2] and the FFC connector [3].
3.
Remove all the fixation screws from the SSB [4].
4.
The SSB can now be shifted from side connector cover,
then lifted and taken out of the I/O bracket. Refer to
for details.
Figure 4-16 SSB removal
19640_114.ep
s
EXA0
3
ECN105
3
2
1
19640_115.ep
s
2
2
1
3
4
4
4
4