Philips 300WN5QS/97, Руководство по обслуживанию

Страница: 26 / 87

300WN5 26
Go to cover page
Display Adjustment
Display Adjustment:
Press and button simultaneously for 10 secs when monitor
on normal mode. Adjust OSD menu to lower position of screen
(i.g. adjust Horizontal OSD Position and Vertical OSD Position to
0 at OSD setting sub-menu. Then press
or button to move
the cursor to red words area ( see red circle on Fig 1). Press
button to access to factory mode (see Fig 2.). Please make
sure firmware version and EDID data are correct. Please do
display alignment after aging 1 hour at least.
Menu
Fig 2. Factory menu :
Fig. 1
2. Apply a 1280x768/60Hz signal with white pattern.Set
brightness control at 50% and contrast control at 50%. Adjust the
R.G.B gain to reach special color temperature on center of
screen.
2.1 Aim the probe CA-A30 at the center of screen as Fig. 4
2.2 Remove the lens protective cover of probe CA-A30.
2.3 Set Measuring/viewing selector to Measuring position for reset
analyzer. (Zero calibration) as Fig. 5
2.4 Turn on the colour analyzer (CA-110).
2.5 Press 0-CAL button to start reset analyzer. See Fig. 6
Measurement/viewing selector Measurement/viewing selector
cover (black) cover (black)
Fig. 4
Fig. 5
Fig. 6
0-CAL
PC mode WHITE-D adjustment (B)
1 Apply 1280X768/60Hz mode with 5 block pattern as Fig 3. Set
main controls brightness control at 50% and contrast to 50% on
User mode. Set color setting at natural color on User mode. Move
cursor to "AUTO-SUB" item on factory mode, press "menu" key
to active this function, then scaler will adjust SUB-CON, Offset
RGB and Color RGB automatically by it self.
Fig. 3
2.6 Switch light probe to Viewing position.
2.7 Move the Lens barrel forward or backward to get clear image as
shown in Fig. 7
2.8 Switch light probe to Measuring position. It should be able to
indicate colour value on the CA-110.
Measurement/viewing selector Measurement/viewing selector
Fig. 7
Clear image