Mechanical Instructions
4.
4.5.5
IR/LED Board
Refer to
for details.
1.
Remove the fixation screws [1] from the stand bracket, pull
out the assy from the set. Refer to
for details.
2.
Carefully Releas the cover secured by clips, then unplug
the connector [2] from the IR/LED board. The IR/LED
Board can now be lifted and taken out from the cover. Refer
to
for details.
Figure 4-24 IR/LED Board removal[1]
Figure 4-25 IR/LED Board removal[2]
4.5.6
Power Supply Unit (PSU)
Caution: it is mandatory to remount all different screws at their
original position during re-assembly. Failure to do so may result
in damaging the PSU.
1.
Gently unplug all connectors from the PSU.
2.
Remove all fixation screws from the PSU.
3.
The PSU can be taken out of the set now.
4.5.7
Speakers
1.
Gently release the tapes that secure the speaker cables.
2.
Unplug the speaker connector from the SSB.
3.
Take the speakers out.
When defective, replace the both units.
4.5.8
LCD Panel
1.
Remove the SSB as described earlier.
2.
Remove the PSU as described earlier.
3.
Remove the keyboard control panel as described earlier.
4.
Remove the stand bracket as described earlier.
5.
Remove the IR/LED as described earlier.
6.
Remove the fixations screws that fix the metal clamps to
the front bezel. Take out those clamps.
7.
Remove all other metal parts not belonging to the panel.
8.
Lift the LCD Panel from the bezel.
When defective, replace the whole unit.
4.6
Assembly/Panel Removal (for 6300 series)
Instructions below apply to the 48PFT6300/12, but will be
similar for other 6300 series models.
4.6.1
Stand
for details.
1.
Remove the screws [1] that secure the black plastic and,
gently remove the black plastic casing that covers the
stand bracket, refer to
2.
Remove the Allen screws [2] that secure the stand bracket
and, pull out the stand downwards from the set, refer to
19791_107.eps
1
1
19791_109.eps
2
