Philips 200P4VG/00, Руководство по обслуживанию

Страница: 15 / 77

Uh3 200P4
15
Go to cover page
Display Adjustment
Display Adjustment:
Press and button simultaneously when monitor power
on. Adjust OSD menu to lower position of screen (i.g. adjust
Horizontal OSD Position and Vertical OSD Position to 0 at OSD
Control sub-menu. Then press
or button to move the
cursor to yellow area ( see red circle on Fig 1). Press
button to access to factory mode (see Fig 2.). Please make sure
firmware version and EDID data are correct. Please do display
alignment after aging 1 hour at least.
Auto Left
Up Down
Menu
Fig 2. Factory menu :
Fig. 1
2. Apply a 1280x1024/60Hz signal with white pattern.Set
brightness control at 100% and contrast control at 50%. Adjust
the R.G.B gain to reach special color temperature on center of
screen.
2.1 Aim the probe CA-A30 at the center of screen as Fig. 4
2.2 Remove the lens protective cover of probe CA-A30.
2.3 Set Measuring/viewing selector to Measuring position for reset
analyzer. (Zero calibration) as Fig. 5
2.4 Turn on the colour analyzer (CA-110).
2.5 Press 0-CAL button to start reset analyzer. See Fig. 6
Measurement/viewing selector Measurement/viewing selector
cover (black) cover (black)
Fig. 4
Fig. 5
Fig. 6
0-CAL
PC mode WHITE-D adjustment (B)
1 Apply 1280X1024/60Hz mode with 64 gray level pattern as Fig
3. Set main controls brightness control at 100% and contrast to
50% on User mode. Set color setting at original panel color on
User mode. Move cursor to "AutoColor" item on factory mode,
press "OK" key to activate this function.
Fig. 3
2.6 Switch light probe to Viewing position.
2.7 Move the Lens barrel forward or backward to get clear image as
shown in Fig. 7
2.8 Switch light probe to Measuring position. It should be able to
indicate colour value on the CA-110.
Measurement/viewing selector Measurement/viewing selector
Fig. 7
Clear image
http://www.wjel.net