Philips 190S8FB/00, Руководство по обслуживанию

Страница: 103 / 112

103
103
HUDSON 8
5.8 If paint is used
z RoHS required
z WEEE require
z If new painting type need to implement, refer to UN-D 1235.
5.9 Plastic mold tooling
z Tooling to be designed to minimize cosmetic defects induced by molding process (sink, blush, weld lines,
gate marks, ejector marks, etc.). Refer to “TYV61-90007”.
z Painting to cover up cosmetic defects due to molding is strongly discouraged.
5.10 Plastics flammability
z All Plastics to be Flame Retardant UL 94-V0 or Better (if monitor weighs less than 18kg; UL94-V0 is OK).
z Base / Pedestal to be Flame Retardant UL 94-HB.
z All major plastic parts (bezel, back cover, base) need to be molded from same resin.
z ABS V0 is allowed to implement in China region for monitor body major plastic parts
(bezel, back cover, base).
z Plastic resin type selection should be referred to “TY R83-2-9002-1”s.
5.11 Texture/Glossing of housing
z The texture area and texture no should follow Philips make-up sheet.
z The exterior surfaces shall have a uniform texture.
z Philips must approve the mold texturing.
z Detail document for texture refer to “UN-D249”, “UN-D 600”.
z < = 20 gloss units
5.12 Tilt and swivel base
z Tilt angle : -5
°
+2/- 0
°
(forward)
+20
°
+3/-0
°
(backward)
z
Swivel angle : ±45° ( not request for 190S8 )
z
High Adjustment : 130mm ( not request for 190S8 )
z Portrait Display : -1° +1/-0°~+91° +0/-1° CCW ( not request for 190S8 )
5.13 Kensington Lock
z Must meet Kensington_slot.spec “TYE-M0004”.
z
MMD request metal plate in Kinsington hole.
5.14 Label
z Regulatory label / Carton label should follow Philips requirement.
z
China RoHS label
z Detail document refer to Philips Engineering Reference Book.