Product Information
The test utility highlights each speaker that is being tested. See
Figure 8
. Click any speaker icon to send the
test sound to the corresponding speaker. If headphones are plugged in, the speaker icons are grayed out and
you can click the left or right headphone icon instead.
The
Loop
test button allows the test to repeat until the
Stop
button is pressed. If the
Loop
is off, the sound will
play once for each click of a speaker or headphone icon.
The
Auto
button sends the test sound to each output once and then moves to the next one automatically. If the
Loop
and the
Auto
buttons are used in conjunction, the test signal will loop through the available outputs until
the
Stop
button is pressed.
Preamp Slider
The Preamp Level control allows you to boost the input audio signal before it is processed by the PSA2. It has
a similar effect as the master volume, but should not be used instead of it.
NOTE:
Increasing the PreAmp may cause audio distortion on some high level input signals. In some cases, an
input signal can be of such amplitude that audio distortion can occur at the preamp default level. If this is the
case simply lower the preamp level to help eliminate any distortion.
Subwoofer Slider
The Subwoofer Level control enables you to set the level of the derived Subwoofer output relative to the left
and right speakers.
Balance Slider
This slider allows you to adjust the balance between left and the right speakers or headphones. For best 3D
effects it should normally be left in the center. Right-click the slider to center it.
3.3.4. Mixer Tab
The Mixer Tab allows you to control playback and recording sources. Two sub-tabs at the bottom of the Mixer
screen provide access to Playback or Recording controls.
3.3.4.1. Source controls
When the
Playback
Sub-tab is selected, you can individually
mute
or un-mute as many playback sources as
you wish using the Mute buttons.
When the
Recording
Sub-tab is selected, you must
select
the single source you wish to record by clicking its
Select button. See
Figure 9
.
Volume sliders set the level for each source.
Balance sliders adjust the relative left and right output levels for each stereo source. Balance sliders should
normally be left in the center, the default position. Right-click any of the balance sliders to center it.
file:///D|/My%20Documents/dfu/190G6/english/190g6/product/product.htm (14 of 20)2005-08-23 1:18:41 PM
Содержание 190G6
