GENERAL PRODUCT SPECIFICATION
8639 000 10649
590
12
23
56 107P2 CM 25 GSIII
CM25-17" 107P2 92KHz AR CRT
TYPE
: 107P20/00H
BRAND : PHILIPS
00-06-07
K.C. Huang
00-06-07
4.6 Geometric distortions
It is acceptable that pincushion, trapezoid, r homboid,
rotation and various waves distortions must remain within
the limits of tolerance as in fig. 4,
½
A
½
,
½
B
½
2.0mm
½
C
½
,
½
D
½
2.0mm
The waviness of any vertical or horizont al shall be less
than 1.0 mm over a 50 mm distance.
4.7 Image non-linearity pattern with
10 equal blocks along horizontal axis,
8 equal blocks along vertical axis.
Overall
:
=
5% (each horizontal and vertical)
:
=
6 % (VGA)
Deviation of Two adjacent :
=
3 % (Adjacent block)
=
3.5 % (VGA)
Xmax. - Xmin
H. linearity =
----------------------- x 100%
Xma x. + Xmin
Ymax. - Ymin
V. linearity =
------------------------ x 100%
Ymax. + Ymin
4.8 Mis-convergence
The maximum convergence error to be measured on a white
spot or white display line to represents the maximum distance
between the energy centers of any two primary colors. (See Fig. 6)
Mis-Convergence SPEC.
4.9 Focus check (with 68.7K/85Hz,1024 x 768 mode)
Generate "@" characters (pattern as fig 7) to cover entire of the picture
area (display size respect to fig. 1), adjust brightness control to 50% and
contrast control to obtain 25 FL @ 5 -block pattern, the characters should
be clearly identified in all display area.
4.10 Luminance uniformity
condition : With full white pattern, set contrast control at max. and adjust
brightness control to get 30FL in center
CRT Pitch
0.25mm
the max. deviation to the rest of the s creen shall not exceed 25% of
entire screen with any point.
<
<
<
<