Philips AVENT AVENT SCD525, Руководство пользователя

Страница: 18 / 254

17
Why does the LINK light on the parent unit
light up red continuously and why is the message
‘Searching’ shown on the display?
•
The baby unit and the parent unit are out
of range of each other. Move the parent unit
closer to the baby unit.
•
The baby unit may be switched off. Switch on
the baby unit.
•
The ECO mode is switched on, but the
operating range is too large. Move the parent
unit closer to the baby unit or switch off the
ECO mode.
Why does the battery light on the baby unit
lash red?
The non-rechargeable batteries of the baby unit
are running low. Replace the non-rechargeable
batteries or connect the baby unit to the mains
(see chapter ‘Preparing for use’).
Why does the parent unit beep?
•
If the parent unit beeps while the LINK light
lights up red continuously and the message
‘Searching’ is shown on the display, the
connection with the baby unit is lost. Move the
parent unit closer to the baby unit.
•
If the parent unit beeps and the battery symbol
on the display is empty, the rechargeable
batteries of the parent unit are running low.
Recharge the batteries.
•
If you have switched off the volume while
the sound alert is on, the parent unit beeps
whenever the fourth sound level light lights up
because the baby unit has picked up a sound.
•
If you have set the room temperature range on
the parent unit and the temperature alert is on,
the parent unit beeps when the temperature
drops below the set level or below 14°C or
when the temperature rises above the set level
or above 35°C.
•
The baby unit may be switched off. Switch on
the baby unit.
14 Frequently asked
questions
This chapter lists the questions most frequently
asked about the appliance. If you cannot ind the
answer to your question, contact the Customer
Care Centre in your country.
What is ECO mode? How does this mode help
the environment?
•
The ECO mode has been developed to enable
you to reduce your energy consumption.
Monitoring your baby from a small distance
requires less power than monitoring your baby
from a large distance. When you monitor your
baby from a small distance, you can activate the
ECO mode. By switching on the ECO mode,
your baby monitor uses less energy and is
therefore more enviornment-friendly.
Why don’t the power-on light of the baby unit
and the LINK light of the parent unit come on
when I press the on/off buttons of the units?
•
Perhaps the batteries of the parent unit are
empty and the parent unit is not in the plugged-
in charger. Insert the small appliance plug into
the charger, put the adapter of the charger
in a wall socket and place the parent unit in
the charger. Then press the on/off button to
establish connection with the baby unit.
•
Perhaps the non-rechargeable batteries of the
baby unit are empty and the baby unit is not
connected to the mains. Replace the non-
rechargeable batteries or connect the baby unit
to the mains. Then press the on/off button to
establish connection with the parent unit.
•
If the LINK light on the parent unit still does not
start to lash, use the reset function to reset the
units to their default settings.
E
NG
L
IS
H