Manual EM-box 3
Hardware 3.1 - REV 3B - JAN 20
Page 3
1.
Safety
o No changes may be made to the device, otherwise the CE mark will be removed.
o The EM-box may only be connected by qualified electricians.
o Before connecting the EM-box, the battery leads must be disconnected. Ensure that the polarity of the batteries is
correct!
These installation and operating instructions are part of the component delivery. It must be kept in a safe place -
important for later maintenance work - and passed on to any subsequent owners of the EM-box.
Exclusion of liability
philippi elektrische systeme cannot monitor compliance with the operating instructions or the conditions and methods
of installation, operation, use and maintenance of the EM-box. Therefore, we do not assume any responsibility and
liability for loss, damage or costs resulting from incorrect installation and improper operation.
Warranty
We provide a warranty for the delivered equipment based on our "General Terms and Conditions - Section 7". These
terms and conditions are the basis of all sales and delivery offers, they are printed in our catalogues and attached to
all offers and order confirmations.
CE mark
This device meets the requirements of the EU directives: 2014/30/EC "Electromagnetic compatibility" The conformity
of the device with the above directives is confirmed by the CE mark.
Intended use
The EM-box serves as a high current distributor for battery systems with a nominal DC voltage of 12V or 24V and
must be installed in dry locations.
Scope of delivery
- EM-box 12V or 24V
- Operating instructions
- 2x pluggable terminals MC1,5/13-STF-3,81 for control and measuring lines
- Plug-in terminal MSTB2.5/4-STF-5.08 for continuous positive
- Plug-in terminal PC5/4-STF-5.08 for charging inputs
- Pipe socket wrench SW13 (M8)
Key to the symbols
Battery Charger
Alternator
Battery
Starter
Panel
Charger/Inverter
Bow thruster
Bilge pump Engine-Ventilator Monitor PSM
Solar
Windgenerator
Hydro-Generator
