*Binary Switch
This device is able to work as an On/Off state switch by pressing
the touch button when fitting horizontal.
Association
This device supports 2 association groups which every group has
eight node support.
To build/disable association between devices,
1. Have the Z-Wave controller entered association mode.
2. Rotate PSR07 to area A then touch the button.
Group 1 is for receiving the report message, like the battery level.
Group 2 is for light control, the device will send Basic Set
command to this group.
Timing Report
The device supports the timing unsolicited report of the status.
• Battery level report: Every 6 hours report once in default.
It could be changed by setting the configuration NO. 10.
• Low battery report: When the battery level is too low, every 30
minutes will report once.
Z-Wave
TM
Notification
After the device adding to the network, it will wake-up once per
day in default. When it wake-up it will broadcast the “Wake Up
Notification” message to the network, and wake-up 10 seconds for
receive the setting commands. The wake-up interval minimum set-
ting is 30 minutes, and maximum setting is 120 hours. And the in-
terval step is 30 minutes. If the user want to wake-up the device
immediately, please rotate to area A and pressing the touch but-
ton once. The device will wake-up for 10 seconds every single
time.
Configuration
NO. Name
Size
(Byte)
Def.
Valid
Values
Description
1
Basic Set
OFF level
1
0x00 0x00~0x63
Control the value represented
by the left-side in area D.
E.g. Setting this configuration
to 0x0F means range of
Command Basic Set value
start from 0x0F
2
Basic Set
ON level
1
0x63 0x00~0x63
Control the value represented
by the right-side in area D.
E.g. Setting this configuration
to 0x1E means range of
Command Basic Set value
start from 0x1E
10
Auto
Report
Battery
Time
1
12
1~127
The interval time for auto re-
porting the Battery level. 0
means turn off auto report
battery.
The default value is 12.
25
Dimmer
Set
Method
1
0x00 0x00,0x01
Dimmer setting method.
0 : Auto send Command Ba-
sic Set after rotating.
1 : Send Command Basic Set
by touching key after rotating
Installation
1. Fix the bracket on the wall.
2. There's a magnet on the backside of this device. It can stick to
the bracket.
Notice: Do not install the bracket on unstable wall, this
may cause miscarriage to control lights.
3
