Philco TeraDry 20, Инструкция по эксплуатации

Страница: 32 / 38

31
the compressor stops working and fan stops working after 30 seconds’ delay.
Both fan speed and humidity can be adjusted under auto mode.
● Continuously drying mode : The machine continues to run, but the humidity can not be
adjusted.
● Sleeping mode : Touch the sleep button, the button lights up and start the sleep function.
Long Press and hold the sleep button 3S to reset the filter
Timer
Press the timer button to set the 0-12 hour timing function. The interval is 1 hour. Each time you
press this button, the value increased 1 hours and then the corresponding timing value is
displayed on the screen. The setting value is “00” to cancel the timer funct ion. The indicator turns
out. After the timer is set and completed, the timer LED is on during the timing period. After the
timing is over, the timer LED turns off automatically.
In the running state, set the time to turn off the machine;
in the standby state, set the time to turn on the machine.
Note: when press POWER will also exit the timer setting.
Speed
Only in automatic mode, touch this button to switch between high and low fan speed, and the
indicator light is on
Up
Press this button to set up humidity and timing time;
Humidity adjusting the order of 30% to 35% - 40% - 45% - 50% - 55% - 60% - 65% - 70% - 75% - 80% - 30%;
Time set to 00, press this key, display 00 and blink, then press this key again every time, from 01-02-03-......
Minus 12 goes all the way up to +1
Down
Press this button to lower humidity setting and timing time;
Humidity adjusting the order of 30% to 80% - 75% - 70% - 65% - 60% - 55% - 50% - 45% - 40% - 35% - 30%;
Time set to 00, press this key, display 00 and blink, and then press this key again every time, from
12-11-10-...... The value of -00 keeps repeating -1