Philco PW 38 D, Руководство пользователя, Страница: 20 / 22

EN - 18
07/2015 Copyright © 2015, Fast ČR, a. s.
PART 6: WHAT SHOULD I DO WHEN...
If the appliance is not working as it should, prior to calling an authorised service centre, read the instructions
below, which will help you remedy the most common problems with the appliance. However, should the
problem persist or you are unable to remedy it yourself, immediately turn the appliance off , disconnect it from
the power socket and contact an authorised service centre.
Under no condition should you repair the appliance yourself.
Important
The noise from the compressor and cooling circuit during operation is normal and does not constitute
a defect.
Problem Possible solution Remedy
The wine is too warm.
The temperature is set
incorrectly.
See chapter "Operation".
The door was left open for
a long time.
Only open the door for the time really needed.
The appliance is near a heat
source.
See chapter "Installation".
The inside light is not
working.
The light bulb is faulty. See chapter "Maintenance".
Thick ice deposit layer,
or potentially also on
the door gasket seal. The door gasket seals are not
air-tight (possible after the
hinges are changed).
Carefully heat the area of the leak of the door
gasket seal using a hair dryer (not hotter than
50 °C) whilst simultaneously moulding the
heated gasket seal with your hands to make it
fi t correctly.
Unusual sounds.
The appliance is not level. Level it using the feet.
The appliance is touching a wall
or other objects.
Move the appliance.
Some of the parts on the rear
side of the appliance, e.g. tubes
are touching a diff erent part of
the appliance or a wall.
If necessary, carefully bend the part so that it
is not in the way.
The compressor starts
immediately after the
temperature is set.
This is normal, this is not
a malfunction.
The compressor starts after a certain interval.
There is water on the
fl oor.
The water drain hole is clogged. See chapter "Cleaning".