Philco PW 143 GLV, Руководство пользователя

Страница: 11 / 119

Copyright © 2020, Fast ČR, a. s. Revision 05/2021
EN - 9
ACCESSORY INSTALLATION BEFORE OPERATING

UNPACKING AND CLEANING THE WINE COOLER
• Remove the exterior and interior packing materials.
• Let the appliance stand upright for approximately 24 hours before connecting it to the power
source, which helps to reduce the possibility of a cooling-system malfunction from handling during
transportation.
• Use a soft cloth to clean the interior surface with lukewarm water.
IMPORTANT: The front louver at the base of the appliance is for ventilation. Nothing should be placed
in front of this front louver; otherwise your Wine Cooler may not operate properly.
o A decorative plinth can be fitted to the front of the base vent, a cut-out should be made in the plinth with
bigger size than the front louver. The cut out is required whether the front louver is removed or not.

ADJUSTING THE HEIGHT AND LEVELLING OFF YOUR WINE CABINET
o The appliance is equipped with adjustable feet, so that the height may be adjusted to level the cabinet on
uneven floor surfaces.
o We recommend that two people carry out this procedure.
o The height must be adjusted prior to building the appliance into the housing unit and it should be set at
such a height that the top panel of the appliance fits exactly below the kitchen worktop.
o Tilt the appliance approximately 60° to allow access to the adjustable feet.
o Take care to ensure the cabinet is supported at all times.
o Twist the foot into a suitable position to level the cabinet.
o Repeat these steps for the other adjustable feet.