Philco PTL7100P, Руководство пользователя

Страница: 16 / 24

3. Remove the drain hose from the rear
support and unhook it from sink or
spigot.
4. Put the ends of each drain and inlet
hose in a container. Let the water flow
out of the hoses.
5. Set the Drain programme and let it
operate until the end of the cycle.
6. Turn the programme knob to position
OFF to deactivate the appliance.
7. Disconnect the appliance from the
mains socket.
WARNING! Make sure that the
temperature is more than 0°C
before you use the appliance
again. The manufacturer is not
responsible for damages
caused by low temperatures.
TECHNICAL DATA
Dimension Width/ Height/ Depth/ To‐
tal depth
400 mm/ 890 mm/ 600 mm/ 600 mm
Electrical connection Voltage
Overall power
Fuse
Frequency
220-230 V
2200 W
10 A
50 Hz
Level of protection against ingress of solid particles
and moisture ensured by the protective cover, except
where the low voltage equipment has no protection
against moisture
IPX4
Water supply pressure Minimum
Maximum
0,5 bar (0,05 MPa)
8 bar (0,8 MPa)
Water supply
1)
Cold water
Maximum Load Cotton 7 kg
Energy Efficiency Class A+++
Spin Speed Maximum 1000 rpm
1) Connect the water inlet hose to a water tap with a 3/4'' thread.
TROUBLESHOOTING
WARNING! Refer to Safety
chapters.
Introduction
The appliance does not start or it stops
during operation.
First try to find a solution to the problem
(refer to the table). If the problem persists,
contact the Authorised Service Centre.
With some problems, the acoustic
signals operate and the display shows
an alarm code:
•
- The appliance does not fill with
water properly. Start the appliance
again by pressing START/PAUSE
button. After 10 seconds the lid will be
unlocked.
• - The appliance does not drain
the water.
• - The appliance lid is open or not
closed correctly. Please check the lid!
16