Philco PLS 1051 F, Руководство пользователя

Страница: 25 / 88

EN - 23
05/2013 Copyright © 2013, Fast ČR, a. s.
There is an excessive
amount of foam in the
drawer for washing
detergent.
You have used a wrong amount of
washing detergent.
Press the Start/Pause button. You can prevent
foam from forming by pouring a mixture of half
a spoon of fabric softener and half a litre of water
into the washing detergent drawer.
Press the Start/Pause button again after
5-10 minutes. When you wash again, use the
correct amount of washing detergent.
Unsuitable washing detergent.
Only use washing detergents specially made for
automatic washing machines.
Unsatisfactory wash
result.
The degree to which your laundry
is soiled does not correspond to
the program you selected. Select a program appropriate for the given degree
to which your laundry is soiled. (More information
in the program chart.)
Insuffi cient amount of washing
detergent.
Use an amount of washing detergent that
corresponds to the level of soiling.
You exceeded the maximum
recommended laundry load in
the drum. The laundry load in the washing machine should
not exceed the maximum capacity of the washing
machine.
The water is drained out
of the washing machine
immediately after it has
been fi lled.
The end of the drain hose is
too low relative to the washing
machine.
Locate the drain hose at an appropriate height.
(***)
No water can be seen in
the drum during the
wash. This is not a malfunction.
Water is in a part of the drum that
is not visible.
There are washing
detergent residues on
the laundry. Residues of the washing
detergent in the form of white
stains may appear on the laundry. Set your washing machine to start the addition
rinse program or remove the stains using a brush
after the laundry has dried.
There are washing
detergent residues on
the laundry.
These stains may be caused by oil,
a cream or a lotion. During the next wash use the maximum amount
of washing detergent set by its manufacturer.
Spinning does not take
place or it occurs with
a delay. This is not a malfunction.
The uneven contents testing
system was activated.
The uneven load testing system may be trying
to evenly arrange the laundry in the drum. The
spinning process will commence as soon as the
laundry is arranged evenly.
Next time you wash, arrange the laundry evenly
inside the drum.
(*) See page 18.
(**) See page 4.
(***) See page 6.