Philco PLD 14961 WD, Руководство пользователя, Страница: 48 / 164

EN - 46
02/2013 Copyright © 2013, Fast ČR, a. s.
Unsatisfactory wash
result.
The degree to which your laundry
is soiled does not correspond to
the program you selected. Select a program appropriate for the given degree
to which your laundry is soiled. (More information
in the program chart.)
Insuffi cient amount of washing
detergent.
Use an amount of washing detergent that
corresponds to the level of soiling.
You exceeded the maximum
recommended laundry load in
the drum. The laundry load in the washing machine should
not exceed the maximum capacity of the washing
machine.
The water is drained out
of the washing machine
immediately after it has
been fi lled.
The end of the drain hose is
too low relative to the washing
machine.
Locate the drain hose at an appropriate height.
(*****)
No water can be seen
in the drum during the
wash. This is not a malfunction.
Water is in a part of the drum that
is not visible.
There are washing
detergent residues
on the laundry. Residues of the washing
detergent in the form of white
stains may appear on the laundry. Set your washing machine to start the addition
rinse program or remove the stains using a brush
after the laundry has dried.
There are washing
detergent residues
on the laundry.
These stains may be caused by oil,
a cream or a lotion. During the next wash use the maximum amount
of washing detergent set by its manufacturer.
Spinning does not take
place or it occurs with
a delay. This is not a malfunction.
The uneven contents testing
system was activated.
The uneven contents testing system may be trying
to evenly arrange the laundry in the drum. The
spinning process will commence as soon as the
laundry is arranged evenly.
Next time you wash, arrange the laundry evenly
inside the drum.
The laundry load
detection system is not
activated when laundry
is being placed in the
drum of the washing
machine.
You have not selected a washing
or drying program.
Take the laundry out of the drum of the washing
machine. Turn the program selection dial to
the STOP position and select a program. Put
the laundry back in to the drum of the washing
machine.
this symbol will
appear on the display
and the washing
machine will not start.
The laundry load is greater than
the maximum recommended load
for the given washing or drying
program.
Gradually take laundry out until the symbol
disappears from the display.
The laundry is still wet
after a drying program
has fi nished.
An incorrect drying program was
selected.
The maximum load suitable for
the given program was exceeded.
Select a diff erent drying program for the given
laundry load (see information in the program
chart).
(*) See page 40.
(**) See page 40.
(***) See page 7.
(****) See page 6.
(*****) See page 8.