5
Revison 03/2017
Copyright © 2017, Fast ČR, a. s.
EN
PART 3: BEFORE THE FIRST USE
To ensure the fi rst cup of coffee tastes excellent, you should rinse the coffee maker with water as follows:
1. Pour water into water tank, the water level should not exceed the “MAX” mark in the tank. Then close the
water tank cover.
NOTE:
The appliance is supplied with a detachable tank for easy cleaning, you can fi ll the tank with water fi rstly,
and then put the tank into the appliance.
2. Set steel mesh into metal funnel (no coffee in steel mesh), make sure the tube on the funnel aligns with
groove in the appliance, then insert the funnel into the appliance from the “INSERT” position, and you can
fi x them into coffee maker fi rmly by turning it anticlockwise until it is at the “LOCK” position.
3. Place an espresso cup (your cup) on removable cup shelf. Make sure the operation knob is on the “O”
position.
NOTE:
The appliance is not equipped with jug, please use your jug or coffee cup.
4. Connect to power source, press the power switch to “I” position to power on the unit. The indicators will
fl ashing blue. The appliance will start heating.
5. When the coffee indicator becomes solid, it shows the pre-heating is fi nished. Turn the operation knob to the
“
” position. The water will fl ow out.
6. After about one minute, turn the operation knob to the “O” position to stop brewing, you can pour the water
in container out then clean them thoroughly, now you can start brewing.
NOTE:
There may be noise when pumping the water on the fi rst time, it is normal, the appliance is releasing
the air in the appliance. After about 20s, the noise will disappear.
PREHEATING
To make a cup of good hot Espresso coffee, we recommend you shall preheat the appliance before making
coffee, including the funnel, steel mesh and cup, so that the coffee fl avour can not be infl uenced by the cold
parts.
1. Remove the detachable tank and open the tank cover to fi ll it with desired water, the water level should not
exceed the “MAX” mark in the tank. Then place the tank into the appliance properly.
2. Set steel mesh into metal funnel (without coffee powder), make sure the tube on the funnel aligns with
groove in the appliance, then insert the funnel into the appliance from the “INSERT” position, and you can
fi x them into coffee maker fi rmly by turning it anticlockwise until it is at the “LOCK” position.
3. Place an espresso cup (your cup) on removable cup shelf.
4. Then connect the appliance to power source. Make sure the operation knob is on the “O” position.
5. Press down the power switch to “I” position to power on the unit. The indicators will fl ashing blue. The
appliance will start heating.
6. When the coffee indicator become solid, it shows the pre-heating is fi nished.
