Philco PH-919, Руководство по обслуживанию, Страница: 29 / 50

Problems and Solutions
If a fault occurs, first check the points listed below before taking the set for repair.
If you are unable to remedy a problem by following these hints, consult your dealer or
service centre.
WARNING: Under no circumstances should you try to repair the set yourself, as this would invalidate the guarantee.
Problems Cause Solution
No power
indication
Power plug not connected Plug the power cord into the power supply
TV has not been set to the correct video
input Set correct TV video input format for
receiving the player’s output signals.
No picture
Video cable not firmly connected.
Firmly insert the video cable ends to the
related terminals.
Audio cable not connected tightly
Firmly insert the audio cable ends to the
related terminals.
Power of audio apparatus is off Turn on the power of audio apparatus. No sound
Audio output setting is incorrect
Setup audio output correctly via the setup
menu.
Disc is dirty Take out the disc and clean.
Picture distortion
Fast forward/backward is activated
The picture may be distorted during fast
forward /backward playback.
Brightness
unstable or noisy
Affected by anti-piracy circuit Connect the player directly to TV.
No disc Load a disc.
Disc not compatible
Load a compatible disc (Check the disc
format and its colour system).
The disc is placed upside down
Load a compatible disc (Check the disc
format and its colour system).
The disc not put in the tray correctly Check disc is put in correctly.
Disc is dirty Clean the disc.
Player setting are incorrect Change the setting via the setup menu.
The player does
not work
Parental lock is in effect Disable this function or reset the rating level.
No response to
key press Interference of power wave or other
factors such as static interference Turn off the main switch or pull out the power
plug, plug it in and turn on the power again.
The remote control not pointed at the
remote sensor on the front panel of the
player
Point the remote control at the remote
sensor.
The remote control is out of specified
range Make sure the remote control range within 7
meters to the remote sensor.
Remote control
does not work
Battery power exhausted Replace with new batteries.
Note:
This produce incorporates copyright protection technology that is protected by method
claims of certain of certain U.S. patent and other intellectual Property rights owned by
Macrovision Corporation and other rights owners. Use of this copyright protection
technology must be authorized by Macrovision Corporation and is intended for home
and other limited viewing users only, unless otherwise authorized by Macrovision
Corporation. Reverse engineering or disassembly is prohibited.
27