Philco PFN 1772 EBI, Руководство пользователя, Страница: 20 / 88

Copyright © 2020, Fast ČR, a. s. Revision 10/2020
EN - 18
PART 7: BEFORE CALLING YOUR AFTER SALES SERVICE
Alarm
indicator led
is turning on ERROR TYPE WHY WHAT TO DO
„Failure Warning"
There is/are some part(s)
Out of order or there is a
failure in cooling process
Check the door is open or not.
If the door is not open, call
service for assistance as soon as
possible.
If your freezer is not working properly, it may be a minor problem, therefore check the following, before
calling an electrician to save time and money.
What to do if your appliance does not operate;
Check that;
• There is no power,
• The general switch in your home is disconnected,
• The socket is not sufficient. To check this, plug in another appliance that you know which is working into
the same socket.
What to do if your appliance performs poorly;
Check that;
• You have not overloaded the appliance,
• The freezer temperature set to -16.
• The doors are closed perfectly,
• There is no dust on the condenser,
• There is enough place at the rear and side walls.
If your freezer is operating too loudly;
Normal Noises
Cracking (Ice cracking) Noise:
• During automatic defrosting.
• When the appliance is cooled or warmed (due to expansion of appliance material).
Short cracking:
Heard when the thermostat switches the compressor on/ off.
Compressor noise:
Normal motor noise. This noise means that the compressor operates normally
Compressor may cause more noise for a short time when it is activated.
Bubbling noise and splash: This noise is caused by the flow of the refrigerant in the tubes of the system.
Water flow noise:
Normal flow noise of water flowing to the evaporation container during defrosting.
This noise can be heard during defrosting.
Air Blow Noise:
Normal fan noise. This noise can be heard in No-Frost freezer during normal operation of the
system due to the circulation of air.
If the edges of freezer cabinet that the door joint contact are warm;
Especially in summer (hot weather), the surfaces that the joint contact may get warmer during the operation
of the compressor, this is normal.