
4
Installation Instructions
front
rear- using a venting kit (optional extra)
Universal flexible hose
The exhaust duct must not exceed 2 metres in length
and 100mm in diameter.
Do not install our dryer in a cupboard or small un-vented
laundry unless you are using a venting kit.
There are 2 VENTING OPTIONS
Venting Kit (purchase extra)
If you choose to use an optional vent kit, the exhaust grille at
the front of the dryer will need to be replaced with the outlet
cover from the back of the dryer. Gently prise open the grille,
using a thin blade tool. Next, remove the cover from the back
and clip it into the grille space at the front. The exhaust grille is
not required when using a vent kit.
You can position the vent kit at the back of the dryer to remove
air upwards or sideways.
Inlet and outlet points need clear airflow to prevent overheating,
so ensure there is adequate ventilation. (i.e. open window or
external door.)
If a venting kit is used and the exhaust is discharged out of the
room, there must be adequate ventilation to avoid the back
flow of gases into the room from appliances burning other
fuels, including open fires, when operating the tumble dryer.
This is not applicable where a venting hose is directed to an
open window. The exhaust air must not be discharged into a
flue which is used for exhausting fumes from appliances burn-
ing gas or other fuels.
You can choose to put your dryer :
The appliance must not be installed behind a lockable door, a
sliding door or a door with a hinge on the opposite side to that
of the tumble dryer in such a way that a full opening of the
tumble dryer door is restricted.
on the floor .
on a work bench.
on a wall, upside down or upright, using the included
mounting kit.
on top of a front load washing machine (need to buy an
extra stacking kit).
The exhaust grille has a range of positions, which allows you to
select the optimum exhaust air angle. Simply hold the grille and
rotate it until it hits the built-in stop.
Name Badge
You can invert the name badge when you want to mount your
dryer upside down on the wall.
Use a suitable tool (such as a thin bladed tool). Unclip the badge
from the panel, invert and clip back.