Philco PD 1046 ET, Руководство пользователя

Страница: 27 / 132

Copyright © 2020, Fast ČR, a. s. Revision 12/2021
EN - 25
FAULT POSSIBLE CAUSE TROUBLESHOOTING
Whitish stains remains on dishes.
Not enough detergent used.
Use the correct amount of
detergent, as instructed in the
programme table.
Rinse aid dosage and/or water
softener setting set too low.
Increase rinse aid and/or water
softener level.
High water hardness level.
Increase water softerner level and
add salt.
Salt compartment cap not closed
properly.
Check that the salt compartment
cap is closed properly.
Dishes do not dry.
Drying option is not selected.
Select a programme with a drying
option.
Rinse aid dosage set too low. Increase rinse aid dosage setting.
Rust stains form on the dishes.
Stainless-steel quality of the
dishes is insufficient.
Use only dishwasher-proof sets.
High level of salt in wash water.
Adjust the water hardness level
using water hardness table.
Salt compartment cap not closed
properly.
Check that the salt compartment
cap is closed properly.
Too much salt spilled in the
Dishwasher while filling it with
salt.
Use funnel while filling salt to the
compartment to avoid spillage.
A poor mains grounding.
Consult a qualified electrician
immediately.
Detergent remains in the
detergent compartment.
Detergent was added when the
detergent compartment was wet.
Make sure detergent
compartment is dry before use.