twin
TM
buggy
twin instructions
assembling your new phil`teds twin
is effortless and fun. just follow these simple
steps and in 5 minutes you’ll be off!
bits ` bobs
red numbers below refer to buggy parts
indicated inside back flap of this guide.
1.
rear wheels
2.
sun hood
3.
front wheels
4.
rear wheel axles
5.
handle
6.
back flaps
7.
footwell
8.
swivel locks
9.
harness
10.
fold lock
11.
auto frame lock
12.
wrist strap
safe ` sound
we’ve attained the following safety standards:
•
EN 1888:2005
•
AS/NZS 2088:2000
•
ASTM F833-07a
wheeling ` dealing
keep tyres inflated to 22PSI max.
a
release fold lock by pushing in grey button.
b
to attach rear wheels: insert axles into rear
wheels (from side without brake disk).
depress
black axle hub and insert into
buggy axle housing.
c
lift footwell as far as hinge will allow.
d
to attach front wheels: fully extend swivel
lock and insert wheel rod into buggy frame,
as shown. release swivel lock and check
wheel is in place for use.
to lock/unlock swivel wheel: extend and
rotate swivel lock, aligning silver pin with
hole in underside of swivel lock knob.
turn wheel towards rear of buggy (parallel
with rear wheels). lock will click into place.
to swivel: extend black swivel lock out and
rotate until knob rests on silver pin instead
of being inserted into hole.
gettin’ it together
e
turn buggy over onto 4 wheels. pull up
handle until you hear a resounding ‘click’.
ensure that auto frame locks are engaged.
2
