FILLING THE BATTERY:
Connect the black output hose (CRT-120) of the tank
to the Quick Connect coupling on the Watering Gun.
Follow the instructions included with the Watering Gun
to fill the batteries or as follows:
Squeeze the Watering Gun handle until all the air in the
hose has been discharged and the water flow is
smooth.
Practice using the Watering Gun in a bucket. Follow
the instructions on the Gun box or as follows:
* Squeeze the handle to start flow.
* Dip the end of the nozzle into the water.
* Notice that the Gun will immediately shut
off.
* Notice how the pump on the cart shuts off
by itself.
* Release the handle to allow the Gun to
reset (If you do not release the handle, the
Gun will not reset.)
Now fill the cells of a motive power battery. Adjust the
level control o-rings on the Watering Gun to suit the
battery. Do this by moving the black level control rings
up or down on the nozzle as needed.
Insert the nozzle of the Battery Watering Gun into the
battery cell. Squeeze the handle until you feel the Gun
shut off. Release the handle. Remove the Gun and tap
to eliminate any drips. Move to the next cell.
Installation and Operation Instructions
10 Gallon Mobile Bladder Cart (CRT-T10G)
1.
2.
3.
4.
5.
PAK124
Revised 10/00
Copyright
2000 by Philadelphia Scientific. All rights reserved.
Philadelphia Scientific is a trademark of Philadelphia Scientific.
Page 2
