NOTE: CRT-T10G is not designed for use with the
Water Injector System.
INSTALLATION:
Attach the female Quick Connect coupling (CRT-123)
to a pressurized water main.
OPERATION:
FILLING THE TANK:
NOTE: If your water main has very low static water
pressure, you may need to use a Booster Pump (INJ-
BP) to increase the tank’s water capacity. To tell
whether you need a Booster Pump or not, you can
either connect up the tank and see how full it gets, or
you can use a static pressure gauge (INJ-PG) to find
out your pressure.
WARNING: Do not fill with water
pressurized at over 100 psi.
The following table indi-
cates the tank capacity based on pressure.
The pressure gauge (CRT-121) located on the top of
the bladder tank shows the pressure inside. If the
gauge shows the pressure is less than 30 psi, the
tank should be filled.
Do not change the factory set
air pressure on the top of the Bladder Tank.
Snap the black input hose (CRT-116) to the Quick
Connect coupling (CRT-123) that you have installed
on your water source. Turn on the water.
Wait until the pressure gauge (CRT-121) has stopped
moving (usually 5 - 10 minutes), then turn off the tap
and disconnect the hose. Wrap the input hose (CRT-
116) around the handle and the output hose (CRT-
120) around the front of the pressure gauge bracket
for storage.
INSTALLATION & OPERATION
INSTRUCTIONS
10 GALLON MOBILE BLADDER CART(CRT-T10G)
FOR USE WITH BATTERY WATERING GUNS
1.
1.
2.
Water Pressure
(PSI)
80
70
60
50
Tank Capacity
(US Gallons)
10.0
9.5
8.0
6.0
Output hose
(CRT-120)
Pressure Gauge
(CRT-121)
Input Hose
(CRT-116)
Quick Connect
(CRT-123)
Page 1
