Phiaton BT 150 NC, Руководство пользователя, Страница: 11 / 16

11
Bluetooth Power
ON/OFF & CALL Button
11. USING THE CALL FUNCTION
1) Accepting a Call
- When the incoming call tone is heard through the earphones or the
incoming call vibration is ringing, press the CALL/POWER Button.
(If you are listening to music when the call comes in, your music will
be paused when you press the CALL/POWER BUTTON.)
- Adjusting Call Volume: to control the call volume, sweep the touch
panel of the left side (while wearing BT 150 NC) to top (+) / bottom
(-) ward.
Status LED Indicator
Incoming Bell/Outgoing Bell Purple light blinks in 1.5 second intervals
During Call Blue light slowly blinks every 6 seconds
When there are two calls connected Purple light slowly blinks every 6 seconds
Left Side(while wearing BT 150 NC)
7) Stopping Incoming Call Vibration
- During on incoming call, shortly press the PLAY/PAUSE Button to stop vibration feature.
You will then only hear the incoming call tone.
2) Ending a Call
- While on a call, shortly pressing the CALL/POWER Button to end the call. (If you were listening to
music when the call came in, your music will resume playing when you end the call.)
3) Rejecting a Call
- When the incoming call tone is heard through the earphones or the incoming call vibration is ringing,
press and holds the CALL/POWER Button for about 1 second. (After providing the ‘beep’ signal tone, the
incoming call is rejected and the ‘Call Ignored’ voice guidance is heard.)
4) Call Waiting
(Supported only when having applied for this service with your telecom provider.)
- When there is another incoming call while on a call.
- Press and hold the CALL/POWER Button for about 1 second to place the current call on call waiting and
connect the second call.
(Press the CALL/POWER Button again for about 1 second to switch between the waiting call and connected call.)
- Shortly press the CALL/POWER Button to end the current call and connect the second call.
5) Calling by Voice
- To place a call by voice, shortly press the CALL/POWER Button and request ‘call contact’ while connected
to the phone.
- This will begin voice command function.
(Supported within mobile phones that support the voice command feature.)
6) Switching between the Device and Mobile Phone
- To switch the call from mobile phone to the headphone, press the CALL Button for 1 second.