11
Operating Instructions
Once the electric heater has been properly installed and connected to a ground
electrical outlet, it is ready to operate.
Note: Ensure the circuit breakers for the power supply are turned on.
Operation with The Control Panel
The control panel is located right side of the heater.
Control Panel
: Press this button to turn ON the fireplace. Press again to turn off the fireplace
and the fan will continue to work for 60 seconds without heat.
: For carbon bed flame effect function - Press this button to change carbon bed
flame color. There are ten types of carbon bed flame effect. Which consists of
yellow, blue, red, green and multi-color. And hold this button for about 3 seconds can
change the brightness of the carbon bed flame.
: For main flame effect function - Press this button to change main flame color.
There are three types of main flame effect. And hold this button for about 3
seconds can change the brightness of the main flame.
: Press this button to set the temperature. Press this button to the desired
temperature. When desired ambient temperature is reached, the heater will
automatically stop heating. When the ambient temperature drops below the
desired temperature 2°C, the heater will resume heating.
Overheat Safety Cut-Off Function
This appliance is fitted with a safety cut-off which will operate if the fireplace
overheats(e.g. Due to blocked air vents). For safety reasons, the appliance will NOT
automatically reset.
To reset the appliance
, plug off the appliance from the main supply for at least
15
minutes
. Reconnect the supply to the mains and switch on the appliance.
