4
3
6. OPERATION CONTROLS AND FUNCTIONS
6.1 Front Panel
SYNC
LINK
EDID
SERVICE
HDMI IN
POWER
HDMI OUT
DC 24V
STD
TV
1
2
3
4
5
6
8
7
1
HDMI IN:
Connect with source equipment such as DVD/Blu-ray or
PS3 player.
2
SYNC:
This LED will illuminate when the HDMI input port connected
to an active source.
3
HDMI OUT:
Connect to HDMI display for instant image display or
cascade with another family type Transmitter.
4
HDMI LINK:
This LED will illuminate when HDMI output is connected
to TV or display monitor.
5
EDID STD/TV:
The default factory setting is on TV, leave as it is
when the display is properly. The unit will detect the 1st CAT5e/6/7
output’s EDID when it obtain a 4Kx2K EDID and send out the signal
accordingly to other output ports. If the 1st CAT5e/6/7 output is
without a 4Kx2K's EDID the unit will detect all output's EDID and
send out the signal that all outputs can accept.
This device obtain the last memory function therefore, the device
will use the last output port 1's EDID when output port 1 is not
connected to a display after power cycling or switch in between
the EDID setting.
Switch to STD to use build-in EDID if the display has problem. STD
EDID's video at 1080p@60Hz and audio at LPCM 2CH.
6
SERVICE:
This slot is reserved for factory service only.
7
POWER LED
: Once the power supply is connected the LED will
illuminate
8
DC 24V:
Plug the 24V DC power supply into the unit and connect
the adaptor to an AC outlet.
4
6.2 Rear Panel
MODE
LINK
MODE
LINK
MODE
LINK
IR IN
IR OUT
LAN
2
3
1
CAT5e / 6 / 7 OUT
1
2
3
4
1
IR IN:
Connect with IR Extender to receive IR signal from Transmitter
side and blast out at Receiver side. Ensure that remote controller
being used is within he direct line-of-sight of the IR Extender.
2
IR OUT:
Connect with IR Blaster to blast out the IR signal received
from the Receiver side. Place the IR Baster in direct line-of-sight of
the equipment to be controlled.
3
LAN:
Connect to intranet or internet service system for a total
sharing rate of 100Mbps within the link of Transmitter.
Warning: DO NOT connect this slot with any of the CAT5e/6/7 port,
doing so may trigger a power shot down and ruin the device.
4
CAT5e/6/7 OUT 1~3:
Connect these ports to CAT5e/6/7 to HDMI
Receivers (with or without PoE function) with CAT5e/6/7 cable to
extend the signal up to 100m.
