2
2
5. FEATURES
•
HDMI with 3D & 4Kx2K supported, HDCP and DVI compliant
• Simultaneous HDMI and CAT5e/6/7 outputs
• Supports one HDTV and seven CAT5e/6/7 outputs
• Supports data rate from 250Mbps up to 3Gbps
• Supports wide range of PC resolutions from VGA to WUXGA
and HDTV resolutions up to 4Kx2K (3840x2160@24/25/30Hz and
4096x2160@24Hz).
• Supports LPCM 7.1CH, Dolby TrueHD, Dolby Digital Plus and DTS-HD
Master Audio transmission (32-192kHz sample rate)
• Supports distances up to 60 meters through CAT5e/6/7 cables
• Supports selection of Standard or TV EDID settings
• Supports USB service port
• Supports Bidirectional IR control
• The 3D signal display follow by display TV’s EDID
Note:
1. This system was tested with CAT6/23AWG cables, results may vary
with cables of a different specifi cation.
2. Displaying HDMI 4Kx2K resolution require the standard 4Kx2K HDMI
cable and display in order for proper image displaying.
3
6. OPERATION CONTROLS AND FUNCTIONS
6.1 Front Panel
POWER
SYNC
HDMI
LINK
LINK 1
LINK 2
LINK 3
LINK 4
LINK 5
LINK 6
LINK 7
CAT5e/ 6 / 7 OUT
1
2
3
4
1
POWER LED:
Once the power supply is connected the LED will
illuminate.
2
SYNC:
This LED will illuminate when the HDMI input port connected
to an active source.
3
HDMI LINK:
This LED will illuminate when HDMI output is connected
to TV or display monitor.
4
LINK 1~7:
The link LED will illuminate when both the input source
and output display signals are connected through CAT cable.
6.2 Rear Panel
1
HDMI OUT
HDMI IN
2
3
4
5
6
7
SERVICE
CAT5e/ 6 / 7 OUT
STD TV
DC 24V
IR IN IR OUT
EDID
1
2
3
6 7 8
4 5
1
HDMI IN:
Connect with source equipment such as DVD/Blu-ray or
PS3 player.
2
HDMI OUT:
Connect to HDMI display for instant image display or
cascade with another family type Transmitter.
3
CAT5e/6/7 OUT 1~7:
Connect these ports to CAT5e/6/7 to HDMI
Receivers with CAT5e/6/7 cable to extend the signal up to 60m.
4
IR IN:
Connect with IR Extender to receive IR signal from Transmitter
side and blast out at Receiver side. Ensure that remote controller
being used is within the direct line-of-sight of the IR Extender.
5
IR OUT:
Connect with IR Blaster to blast out the IR signal received
from the Receiver side. Place the IR Blaster in direct line-of-sight of
the equipment to be controlled.