4
4
6.2 Rear Panel
POWER
DC 24V
CAT5e/6 OUT
IR 1
BLASTER
USB
LINK
IR 2
EXTENDER
1
2
3
4
5
6
7
1
POWER LED:
Once the power supply is connected the LED will illuminate.
2
DC 24V:
Plug the 24V DC power supply into the unit and connect the
adaptor to an AC outlet.
3
IR 1 BLASTER:
Connect with the supplied IR Blaster to blast out the IR signal
received from the Receiver side. Place the IR Blaster in direct line-
of-sight of the equipment to be controlled.
4
IR 2 EXTENDER:
Connect with the supplied IR Extender to receive IR signal from
Transmitter side and blast out at Receiver side. Ensure that remote
controller being used is within the direct line-of-sight of the IR
Extender.
5
USB:
This slot is reserved for fi rmware update only.
6
LINK LED:
This LED will illuminate when both the input source and output
display signals are connected through CAT cable. When it blinks
regularly it states the display is NOT sending signals to Receiver but
the Transmitter and Receiver are linked and if it blink irregularly it
states an error has occurred.
7
CAT5e/6/7 OUT:
Connect this port to CAT5e/6/7 to HDMI Receiver with CAT5e/6/7
cable to extend the signal up to 60m.
5
6.3 IR Cable Pin Assignment
3
1
3
1
2
2
Power 3.3 V
IR Blaster Signal
NC
IR Signal
Power 3.3 V
Grounding
IR Extender
IR Blaster
6.4. D-Sub 9 Pin Defi nitions
Pin
Defi ne TX / RX
1
N/C
2
TxD/RxD
3
RxD/TxD
4
NC
5
GND
6
NC
7
NC
8
NC
9
NC
