4.
Installing the
Phazzer RailCam™ on a fixed Rail:
Pull up on the two raised side lock buttons located near the rear of the RailCam,
slide the RailCam onto the fixed rail and release. The RailCam will lock into place.
5.
Charging Your Phazzer RailCam™
For optimal performance, please charge your new Phazzer RailCam™ using the included USB
cable for 1.5 hours prior to use.
To charge your RailCam, locate the USB cable that was
provided in the packaging. Plug the smaller end of the
cable into the USB connection slot located on the right hand side of the RailCam.
Connect the other end of the USB cable to the AC Adapter charger or a computer USB
port.
The LED indicator light will alternately flash red and blue lights while
the RailCam is charging.
When the RailCam is fully charged, the indicator light will remain a steady red
light. Unplug the RailCam from the charging port at this time. Avoid
overcharging as this may deplete the battery life.
Turn the RailCam on by pushing the back power button up. Once on, the
indicator light will turn red and blue, then both lights will remain blue during
recording. The indicator light will turn red when the battery is in a low power
state. If there is access to an external power supply, the system can charge
while recording. The indicator light will be blue with the red light flashing. (Power
switch needs to be "On".
Please note: Once the Railcam has been fully charged, the charging time may be
less than the initial 1.5 hrs.
6.
Changing the Time and Date:
There are two ways to operate this function.
The first method
：
Connect the RailCam to your computer using the USB cord.
A window will open up. Double click on
“WriteTime”
A dialog box will appear with the device shown in the box. Select
"Update". Safely remove the RailCam from your computer
Turn on the RailCam once to initiate the reset.
