R
L
1u6 1u6
100 v
100 v
Bi
Di
1u6
1u6
100 v
100 v
Install instructions for CS micro series
, Page 2
2.
Remove the grille from the speaker assembly.
If it is necessary to paint the speaker grille to
match the ceiling, we recommend that you do
so with several light coats of matching spray paint.
3.
Connect the speaker wires to the input
terminals on the rear of the speaker, making
sure no loose strands are exposed.
Speaker Installation:
+
_
Red/positive Black/negative
5.
Carefully replace the grille by pressing it
into the gap between the flange and the
baffle. Enjoy your new Phase Technology
speakers!
4.
Carefully position the speaker in the
cutout hole. Using a Phillips screwdriver,
rotate the four clamps to secure the
speaker to the drywall.
CAUTION: Do not over-tighten.
1.
Using the supplied cutout template,carefully
mark the area to be cut out. Using a drywall knife or
saw, cut a hole in the drywall and prepare the
speaker wires for connection to the speaker
terminals.
**Note
: for the CS-6DVT/Micro there are several
hookup options. For stereo point-source operation,
connect the speaker wires to the Left and Right
channel input terminals on the rear of the speaker.
Make sure no loose strands are exposed.Please
make sure to check your hookup polarity for proper
operation.
+
_
Red/positive Black/negative
For Surround/Mono:
The CS-6DVT/Micro may
also be used as a surround speaker for home
theater applications. For the surround or MONO
mode of operation, connect your speaker wire
to either the left or right channel input as above.
Next connect 2 jumper wires from this same
input terminal to the corresponding input
terminals on the opposite side of the speaker.
Connect the red positive terminal to opposite red
terminal and black negative terminal to opposite
black terminal.
This speaker may be set to either the bi-pole or
di-pole mode of operation using the selector
switch on the rear panel.
Please note that the speaker is a 4 ohm speaker
in this configuration.
Stereo point-source configuration
Surround or MONO configuration
8005 W. 110th St., Suite 208 | Overland Park, KS 66210 | (855)663.5600 | www.phasetech.com | www.mseaudio.com
R
L
1u6 1u6
100 v
100 v
Bi
Di
1u6
1u6
100 v
100 v
