T E C H N O L O G Y
CI-10 VIII CI-20 VIII CI-40 VIII CI-60 VIII CI-72 VIII CI-70 VIII
CI-10 VIII CI-20 VIII CI-40 VIII CI-60 VIII CI-72 VIII CI-70 VIII
CI-10 VIII CI-20 VIII CI-40 VIII CI-60 VIII CI-72 VIII CI-70 VIII
Install instructions for CI rectangular flush mounts models:
6400 Youngerman Circle | Jacksonville, FL 32244 | (888)phase tk | www.phasetech.com
1.
Choose the appropriate mounting
location for each speaker.
Flange Installation:
Speaker Installation:
2.
Remove the speaker and flange/grille
assemblies from their boxes. Using the
supplied cutout template, carefully mark the
area to be cut out. Using a drywall knife or
saw, cut the hole in the drywall and prepare
the speaker wires for connection to the speaker
terminals.
3.
Remove the grille from the mounting
flange by pressing it from behind. Attach
the provided white gasket material to the
outside, rear edge of the flange. Insert the
mounting flange into the hole with the end
marked “TOP” facing up. Loosen the flange
clamping screws one turn (counter clock-
wise) to release the clamp. Use a level to
insure that the flange is square. Next tighten
all 4 flange clamp screws evenly to secure
the flange to the wall. It is best to tighten
each screw with the same amount of force
(torque).
CAUTION:
Do not over tighten.
7.
Tighten down the four QM clamps by
pressing them down flush with the baffle’s
surface.
6.
Insert the baffle into the mounting flange,
aligning QM clamps with the four QM posts.
Also make sure that the tweeter is placed at
the end of the flange marked “TOP”.
4.
Use the provided tool to fully open the four
Quick Mount™ (QM) clamps. If the tool is not
available a small screw driver can be used.
NOTE –
When deciding upon a location
consider the following:
• Be certain your speaker wires can be run to or
are accessible from these locations.
• Make certain the wall or ceiling material is sturdy
enough to support the weight and vibration of the
speakers.
• It is recommended that our pre-construction
rough in brackets (part number RB-18*) be used
whenever possible in new construction.
• Be certain the area behind the speaker is free of
obstacles such as wall studs, electrical wiring,
pipes, etc.
• Each speaker should be positioned properly
relative to the listening area for good coverage.
• Audio performance and room-to-room isolation
will be improved if there is some fiberglass
insulation placed loosely behind the speaker.
8.
Using some familiar source material, listen to
the tweeter’s balance with the level control in
each of its three positions to find your favorite.
9.
Carefully install grille by pressing it into the
gap between the flange and the baffle and enjoy
your new Phase Technology CI speakers.
5.
Connect the speaker wires to the spring
loaded input terminals on the rear of the speaker,
making sure no loose strands are exposed.
red/positive black/negative
+
–
flange screw
