5
[HOW TO HOOK UP YOUR PC3.0 SOUNDBAR]
STEP 1
Determine that the desired mounting location is safe and clear of any physical obstructions that might hinder the proper installation of the
speakers. If the flat panel monitor is already installed on the wall you can use it as a guide for the installation of the speakers. For the best
appearance it is recommended that the speaker be installed symmetrically beneath the monitor. The spacing from the monitor is not critical
so you may use whatever is most appealing aesthetically but the speakers’ response characteristics will be best if you stay within a few inches
of the display.
Special consideration must be taken to run three (3) sets of speaker leads to the TEATRO
®
soundbar speakers. One pair each will be
connected to the left and right channel on your amplifier and the other pair will be used for the center channel. Be certain that you can get
the speaker wire to the locations where you plan to mount the speaker systems.
Please note that the TEATRO
®
soundbar speakers are designed to mount very close to the wall and the brackets only allow about 1” of
clearance so be certain to make allowances for this with your speaker connectors and wire clearances.
We suggest that you use a minimum of AWG #16 wire. Pre-run your speaker wire to the determined locations and be certain to leave about
two feet of extra wire for the final speaker installation. If the flat panel monitor is not yet mounted to the wall, mount the display first before
mounting the speakers.
STEP 2
Normal mounting for the TEATRO
®
soundbar speaker is centered directly below the display. Both the speaker and the brackets have a series
of holes that allow for flexibility in mounting. The brackets can also slide inside each other for left/right positioning adjustments. The holes in
the brackets allow them to be positioned for attaching to 16” on center studs. There are four identical brackets supplied with the speaker. Two
are mounted to the wall, two are mounted to the rear of the speaker cabinet.
[FIGURE 1]
the brackets allow them to be positioned for attaching to 16” on center studs. There are four identical brackets supplied with the speaker. Two
are mounted to the wall, two are mounted to the rear of the speaker cabinet.
Measure your flat panel display horizontally and find the center (width). The brackets should be positioned 5” either side of this center line.
Using the mounting bracket as a guide, measure 1 ½” from the bottom of the display to the top edge of the bracket and 5” over from the
center line to the bracket edge (see Fig. 1). This will allow about a ¼” space between the bottom of the display and the speaker cabinet. This
spacing can be adjusted to suit personal taste or applications as necessary. Use a level to make sure the mounting bracket is straight. With
STEP 3
Place your TEATRO
®
soundbar speaker face down on a soft clean surface with the grille on. Orient the speaker so the input terminal is on
the left hand side. The second pair of steel brackets supplied with the speaker is designed to attach to the threaded inserts on the rear of the
speaker cabinet with the eight supplied 4 mm x .7 x 12 mm Philips screws and #6 washers. Align the holes on the brackets with the center
5”
2.5”
40”
20”
5.5”
11”
12”
24”
7”
3.5”
2”
1”
4.372
”
8.1875”
USE THESE SET OF HOLES FOR SPEAKER
BRACKETS FOR NORMAL WALL MOUNTING
FLAT PANEL WALL MOUNT
ATTACHMENT INSERTS
Содержание TEATRO PC3.0
Страница 1: ...OWNER S MANUAL INSTALL GUIDE ...
