6
4. Unpack speaker. Leave
paint mask in place until after
speaker is installed or painting
is complete.
1. Nail or screw bracket to
joists.
2. Finish installing ceiling.
3. Use RotoZip or other tool to
cut hole. Hole diameter: 5.6 in.
CI1.5 INSTALLATION USING OPTIONAL PRE-CONSTRUCTION BRACKET
5. Connect Euroblock to
speaker wires and connect to
speakers.
6. If required, attach seismic
restraint system to hole in
clamping arm, then to rein-
forced structure (saftey cable
not included)
7. Insert speaker into mounting
hole with paint mask in
place. Tighten both screws
on the baffle face to actuate
the mounting wings. Firmly
secure both screws. DO NOT
OVERTIGHTEN.
8. Remove paint mask unless
painting is required. In that
case, follow steps 8-11 when
painting is complete.
9. Adjust tap switch to proper
setting. Switch is preset to 8
Ohm mode.
1.
2.
10. Attach grille safety clip
by placing the large end of
the clip over snap-fit post (1),
then sliding clip until small end
snaps into place around post
(2).
11. Align tabs on snap-fit grille
with slots in baffle. Gently
press grille into place.
12. DONE!
