background image

Install instructions for CI round flush mount models, Page 2

Flange Installation:

3.

 Connect the speaker wires to the

spring-loaded input terminals on the rear of

the speaker, making sure no loose strands

are exposed. 

Speaker Installation:

+

_

Red/positive         Black/negative

5.

 The tweeter may be aimed toward the 

listening area by 

gently

 applying pressure 

to the inside of the outer edge of the 

tweeter assembly.

6.

 Carefully replace the grille by pressing it

into the gap between the flange and the

baffle. Enjoy your new Phase Technology

speaker!

Grille

SAFETY-LOC™ Clamp

NOTE: Special instructions for non-QM 
Flanges

If you are installing a CI round speaker with 

the QM clamps in a CI-FGR (non-QM flange) 

remove the QM clamp feet by unscrewing 

them from the speaker baffle. Insert the 

speaker baffle into the flange and reuse the 

screws from the clamp feet to attach the 

speaker to the flange.

8650 College Boulevard  |  Overland Park, KS 66210   |  (888)phase tk   |  www.phasetech.com  |  www.mseaudio.com

4.

 Insert the speaker installation tool into 

two of the screw access holes on the 

speaker.  Carefully place the speaker in the 

flange; rotate slightly until the speaker 

surface is even with or slightly recessed into 

the surface of the flange.  While exerting 

upward pressure, use the tool to rotate the 

speaker COUNTER-CLOCKWISE  (left).  This 

will engage the QM SAFETY-LOC clamps on 

the back of the flange.  Remove tool and 

tighten the four clamp screws on the 

speaker.  

CAUTION: do not over-tighten.

CAUTION: Do NOT attempt to rotate the 
speaker by grasping the tweeter!

1.

 Using the supplied template, carefully 

mark the area to be cut out. Using a 

drywall knife or saw, cut a hole in the 

drywall and prepare the speaker wires for 

connection to the speaker terminals. 

Remove the grille from the mounting 

flange by pressing it from behind. Insert 

the mounting flange into the hole.

2. 

Loosen the flange clamping screws one turn 

(counter clockwise) to release the clamp. Next, 

tighten all four flange clamp screws evenly to 

secure the flange to the drywall. It is best to 

tighten each screw with the same amount of 

force (torque). 

CAUTION: Do not over-tighten.

Отзывы: