the front edge of the window opening (or
position as desired), making sure that the
shade is centered in the window opening
– then push up on the screws so that the
screw heads leave tiny impressions in the
top of the window frame. Now, use the
impressions as a guide and pre-drill the
mounting holes using a 5/64” drill bit –
then screw the shade in place.
Attach the Chain Tension Device
The Tension Device must be attached per
these instructions in order for your shade to
function properly.
Carefully unwrap the control cord/chain and
tension device. Cut and remove the zip-tie.
While holding the tension device in one
hand, pull the plunger away from the bead
chain with the other hand. Lift the bead
chain out of the bead locking groove and
slide the tension device to the bottom of the
chain loop.
Pull the tension device down until the bead
chain is fully tensioned (plunger will be at the
top) and then move the tension device up
approximately 1/8”.
Mark the screw locations on the wall or
window frame with a pencil.
Inside Mount:
If mounting into wood, predrill
screw holes and then install the tension
device using the 1” Phillips head screws
provided.
If not securing into wood, use appropriate
anchors for the substrate and follow the
anchor manufacturer’s instructions.
Outside Mount
: Align the mounting bracket
screw holes with the pencil marks. If
mounting into wood, predrill screw holes and
then install the mounting bracket using the
1” Phillips head screws provided.
If not securing into wood, use appropriate
anchors for the substrate and follow
manufacturer’s instructions.
Press the tension device onto the mounting
bracket posts. Carefully install the ⅜3/8”
Phillips head screws provided, through the
tension device into the mounting bracket
using a Phillips head screwdriver.
DO NOT OVER-TIGHTEN!
How to Operate Cord Control Shades
Pulling the cord smoothly and slowly in one
direction raises the shade; pulling it in the
other direction lowers it. On shades where
the fabric rolls against the window, the front
cord lifts the shade. On shades where the
fabric rolls toward the room, the rear cord
lifts the shade.
General Cleaning Guidance:
• Dry Cleaning is the best method to
clean soiled soft window treatments.
• However, on 100% Polyester, Cotton/
Poly blends and 100% Cotton or 100%
Linen you may: Spot clean with warm
soapy water using mild detergent and a
clean sponge. Air-dry and then steam or
iron.
LIMITED LIFETIME WARRANTY
The enclosed product is warranted to the original residential retail purchaser as long as the
product remains in the original window.
Covered
Lifetime:
Entire product against manufacturing defects (i.e. a flaw in the product design,
materials, or workmanship that causes the product to no longer function.
3 Years:
Cords, including internal cords such as those found in cordless blinds or shades.
5 Years:
All fabric
Not Covered
1. Normal wear and Tear
2. Any product that fails due to:
• Abuse • Alterations • Exposure to salt air • Improper cleaning
• Improper installation • Misapplication • Accident
• Damage from pests/insects/pets • Extraordinary use
• Improper handling • Improper operation • Misuse
3. Natural Wood Products that have:
• Loss of color intensity • Variations in color, grain or texture
• Warping of wood slats in high humidity areas
Tension
Device &
Bracket for
Outside
Mount
Chain
Tension
Device
Bracket for
Outside Mount
Window Blind Cord Can
STRANGLE
Your Child
• Children can climb furniture to
reach cords.
• Move crib and furniture away.
• Keep all cords out of children’s
reach.
• Attach tension device to wall or
floor.
• Fasteners provided with tension
device may not be appropriate for
all amounting surfaces.
• Use appropriate anchors for the
mounting surface conditions.
