Installation Instructions for
CUSTOM ROMAN SHADE with CORD CONTROL
from the bead chain with the other hand. Lift the bead chain out
of the bead locking groove and slide the tension device to the
bottom of the chain loop.
Remove the twist-tie from the Cord Control Mechanism.
Pull the tension device down until the bead chain is fully
tensioned (plunger will be at the top) and then move the tension
device up approximately 1/8”.
Mark the screw locations on the wall with a pencil.
Inside Mount:
If mounting into wood, pre-drill screw holes and
then install the tension device using the 1¼” Phillips head screws
provided.
If not securing into wood, use appropriate anchors for the
substrate and follow anchor manufacturer’s instructions.
Outside Mount:
Align the mounting bracket screw holes with the
pencil marks.
If mounting into wood, predrill screw holes and then install the
mounting bracket using the 1¼” Phillips head screws provided.
If not securing into wood, use appropriate anchors for the
substrate and follow manufacturer’s instructions.
Press the tension device onto the mounting bracket posts.
Carefully install the ⅜” Phillips head screws provided, through the
tension device into the mounting bracket using a Phillips head
screwdriver.
DO NOT OVER-THIGHTEN!
How to Operate Cord Control Shades
Pulling gently on the cord in one direction raises the shade;
pulling it in the other direction lowers it.
Care Instructions
The packaging and shipping of soft treatments frequently results
in minor wrinkling of the fabrics used.
There are different characteristics and handling needs for the
variety of fabrics offered in this program.
Please refer to the descriptions below for guidance on how to
remedy minor wrinkles upon delivery.
First, allow all items to hang for a few days so wrinkles relax and
begin to fall out.
Silk fabrics:
• Natural irregularities give the fabric its unique and desired
character. The appearance of slubs, nubs, loops and barre
ridges are universally accepted as normal and should not be
considered defects.
• If necessary, steam silk to remove stubborn wrinkles. Please
note that a good quality steamer is needed so water spots
won’t form from water spitting out from the steaming device.
Rayon/Poly blends:
• If necessary, steam rayon/poly to remove stubborn wrinkles.
Please note that a good quality steamer is needed so water
spots won’t form from water spitting out from the steaming
device.
100% Polyester:
• If necessary, steam polyester or gently iron on a low heat
when turned around to go into the window.
Center the brackets at the pencil marks, and then mark the
screw hole locations for each bracket.
Pre-drill the screw holes with a 3/32” drill bit and attach the
brackets with the screws provided.
4.
Position the shade so that the bottom-front of each bracket
goes through the holes cut in the fabric at the back of the
head rail. A second set of hands is useful, but it can be done
by one person.
Slide the head rail fully into the brackets.
5.
Attach the shade to the brackets using the ½” screws
provided.
Inside Mount – lift the front of the shade to attach the set-screws.
Outside Mount – lift the front valance to attach the set-screws.
Attach the Chain Tension Device
The Tension Device must be attached per these instructions in order
for your shade to function properly.
While holding the tension device in one hand, pull the plunger away
View from
the top
bracket goes through hole cut
in the fabric at the back of rail
Tension Device & Bracket
for Outside Mount
Chain
Tension
Device
Bracket for
Outside Mount
