STEP 5. INSTALL THE BACKPLATE
Carefully position the backplate onto the
graphics card. Align the mounting holes on
the PCB with the holes on the backplate.
Secure the backplate with 11 M2.5x8mm
flush screws to the PCB.
1.
11x
STEP 4. APPLYING THERMAL PADS
Remove the protective film on both sides
and place the thermal pads on the correct
position on the backplate.
STEP 3. MOUNT THE WATER BLOCK
Secure the support bracket to the GPU block
first.
Carefully position the water block onto the
graphics card. Align the mounting holes on
the PCB with the holes on the water block.
Secure the water block with 4 M2.5x5mm
screws and washers to the PCB.
Secure the Support Bracket with the original
cooler screw.
4x
4x
Make sure to lay the GPU with the water
block flat down without resting on the
PCI bracket.
Secure with original
screw.
Always perform a leak test before
providing power to any system components.
STEP 6. INSTALL INTO THE SYSTEM
1. Connect the D-RGB cable to the D-RGB
strip in the water block.
2. Install the GPU into the system.
3. Install the waterloop and Stop Fittings
Use the Motherboard cable to connect
the LED strip to the motherboard.
Opotional:
All Phanteks D-RGB products can be
daisy-chained together.
Connect to
Phanteks Case / Motherboard Cable
2
4
2
3
1
5
1x
5
2
2
3
4
1
