RTX
INSTALLATION GUIDE V1.1
GLACIER G30 STRIX
3090/3080
PH-GB3090ASSRX_BK01/CR01
WARNING
-
been made to provide the most comprehensive information possible, Phanteks assumes no liability expressed or implied for any damage(s) occurring to your
components as a result of using Phanteks cooling products, either due to mistake or omission on our part in the below instructions, or due to failure or defect in
the Phanteks cooling products. Do not disassemble the water block. Warranty will be voided.
PACKAGE CONTENTS
For latest version check www.Phanteks.com
We recommend using isopropanol alcohol.
Apply a drop of the Phanteks Thermal
Compound to the center of the GPU chip
STEP 1. REMOVING STOCK COOLER
GLACIER GB3090ASSRX
QTY: 1
GLACIER Stop Fitting
QTY: 2
Thermal Pads
QTY: 3
M2.5x5 Screws/Washers
QTY: 15/15
Thermal Compound
PH-NDC-01
QTY: 1
Phanteks D-RGB Cable
QTY: 1
Unscrew all highlighted screws to remove
the stock cooler, backplate and heatsink.
STEP 2. APPLYING THERMAL PASTE & PADS
the thermal pads on correct position on
the PCB.
Make sure to unplug the LED and Fan
cables when you remove the stock cooler.
both sides of the thermal pads.
Take the EVA-Foam from the box to use
as a base for your installation process.
STRIX RTX 3080
STRIX RTX 3090
backplate screws
stock cooler screws
5
6
5
6
5
6
1 1 1 1 1 1 1 1 1 1
4 4 4 4 4 4 4 4 4 4 4
2
3
1 1
1 1 1 1 1 1 1 1 1 1
4 4 4 4 4 4 4 4 4 4 4
2
3
1 1
1 1 1 1 1 1 1 1 1 1
4 4 4 4 4 4 4 4 4 4 4
2
3
1 1
5
6
１ １ １
１
１
１
１
１
１
１
１
１
2
3
4
4
4
4
4
4
4
4
4
4
4
１
１
１
１
１
１
１
１
１
１
2
3
5
6
4
4
4
4
4
4
4
4
4
4
4
