STEP 3. MOUNT THE WATER BLOCK
Carefully position the water block onto the
graphics card. Align the mounting holes on
the PCB with the holes on the water block.
Secure the water block with 9 M2.5x5mm
screws and 5 washers to the PCB.
STEP 4. CONNECT D-RGB LIGHTING
Connect the D-RGB cable to the D-RGB strip
in the water block.
STEP 5. INSTALLING FITTINGS
Install G1/4 threaded male fittings and
close the remaining ports with the two
included Stop Fittings.
9x
5x
Connect to
Phanteks Case / Motherboard Cable
Always perform a leak test before providing
power to any system components.
You can connect the D-RGB cable to a
compatible motherboard with the cable
that is included with the motherboard.
Make sure to lay the GPU with the water
block flat down without resting on the
PCI bracket.
All Phanteks D-RGB products can be
daisy-chained together.
5x washer
4x screws only
+
