PG DRIVE TECHNOLOGY NEWVSI, Техническое руководство

Страница: 61 / 68

PG D
RIVES
T
ECHNOLOGY NEW
VSI T
ECHNICAL
M
ANUAL
– W
ARNING
S
UMMARY
SK80151-1 61
2.9 Warranty
The warranty will be void if the newVSI has not been used in accordance with newVSI Technical
Manual SK80151, the newVSI has been subject to misuse or abuse, or if the newVSI has been
modified or repaired by unauthorized persons. Chapter 1 Section 14.
2.10 Program Settings
It is the manufacturers responsibility to program the controller to suit the vehicle model and
ensure safe operation in compliance with relevant legal requirements over the whole of the
operating range. PGDT accepts no liability for losses of any kind due to incorrect programming of
the newVSI controller. Refer to Chapter 3 for Programming details.
Programming should only be conducted by healthcare professionals with in-depth knowledge of
PGDT electronic controllers. Incorrect programming could result in an unsafe set-up of a
wheelchair for the user. PG Drives Technology accepts no liability for losses of any kind if the
programming of the controller is altered from factory pre-set values. PGDT accepts no liability for
losses of any kind if the drive or stability characteristics of the chair are altered without prior
notification and discussion with PGDT. Chapter 2 Section 1.2.
2.11 Charger Interlock
The chair manufacturer is responsible for providing a means of preventing the use of the
wheelchair while the batteries are being charged. PGDT accepts no liability for losses of any kind
arising from failure to comply with this condition. Chapter 2 Section 2.2.
2.12 Wiring
The chair manufacturer is responsible for establishing the suitability of the particular wiring
arrangements used on the wheelchair for both normal use and stalled conditions. PGDT can make
general recommendations for wiring for newVSI controllers, but PGDT accepts no responsibility
for, and accepts no liability for losses of any kind arising from, the actual wiring arrangement
used.
The chair manufacturer is responsible for ensuring that only the mating connectors specified by
PGDT on the controller’s specific data sheet are used to connect to the controller. PGDT accepts
no liability for losses of any kind arising from failure to comply with this condition.
The chair manufacturer is responsible for ensuring that suitable connectors are used and securely
mated throughout the chair wiring system and that the workmanship associated with the wiring
system is of a high enough quality. Failure to meet this condition could result in intermittent
operation, sudden stopping or veering, or even create a burn or fire hazard. PGDT accepts no
liability for losses of any kind arising from failure to comply with this condition. Chapter 2
Section 4.1.
2.13 Battery Wiring
The chair manufacturer must install a suitable circuit breaker to provide protection against short
circuits in the battery wiring, power loom or the controller. Failure to comply with this could
result in a fire hazard. PGDT accepts no liability for losses of any kind arising from failure to
comply with this condition. Chapter 2 Section 4.3.