Page 8
INSTALLATION Cont...
•
Remove the flange and scribe a second circle that has a radius 15mm larger than the first.
•
Cut out around the larger circle (x+15mm radius) and clean up around the hole.
• Liberally apply sealant around the edge of the hole
X
X + 15
Spread sealant on
flange liberally.
TIP
Our current product is Sikaflex PRO
which we have found good in sealing
polyethylene to polyethylene.
•
Place the flange in the hole. Drill pilot holes and fasten in place
with the stainless steel self tapping screws provided. Check that
the Waste Chute fits vertically through the floor before finally
sealing and screwing.
• Place the Waste Chute in position and place the toilet pedestal
onto the Waste Chute. Measure the distance Y (height of
Pedestal above floor).
• Remove the Waste Chute and cut off the measured distance
from the length of the Waste Chute. NB - one end of the Chute
has a socket, which is provided for when more than one Chute
are joined together - this end should be cut off so the final Chute
is smooth and straight.
Waste
Chute
Flange
Floor
•
Replace the Waste Chute. Seal with sealant the inside pedestal lip, where the Waste Chute meets the
pedestal. Fix the pedestal to the floor.
Waste
Chute
Sealant
Sealant
Fixing Vent Pipes
Two Vent Pipe connection Pods are supplied with the Maxi RL2000:
•
One with a hole cut for a 100mm DWV pipe - this is the Inlet connector
•
One with a hole cut for a 150mm DWV pipe - this is the Outlet connector
•
The vent pipes are not supplied with the kit as each installation will be unique. All connections are
designed to fit standard 100 and 150 DWV PVC pipe.
•
Keep bends in vent pipes to 45 degree - 90 degree bends are too sharp and slow the airflow
unnecessarily.
