Pfeiffer Vacuum HILOBE 1004, Руководство по эксплуатации

Страница: 40 / 68

Option Description
1 = No error active, with trouble-free operation
2 = Error active, if the error message is active
5 = Set rotation speed reached active, once the set rotation speed is reached
6 = Pump on active, if pump on, motor on and no error
9 = always 0 GND for the control of an external device
10 = always 1 V+ for the control of an external device
11 = Remote active, if the remote priority is active
Tbl. 13: Configuration with parameters [P:019] and [P:024]
Configure the interface
► Perform the configuration as per the following table:
Option [P:060] Description
1 = remote Operation via connection " remote "
2 = RS-485 Operation via connection " RS-485 "
4 = PV.can For service purposes only
32 = Keys on the front panel Manual operation
Option [P:061]
0 = off Interface selection can be set via [P:060].
1 = on Interface selection locked
Tbl. 14: Configuration with parameters [P:060] and [P:061]
8.4 Operating modes
The following operating modes are possible:
● Operation without control unit
● Operation via an external control unit
● Operation via RS-485 and Pfeiffer Vacuum display and control unit or PC
Automatic start
After bypassing the contacts at pins 2, 7 and 5 on the “remote” connecting plug or when
using a connecting cable with respective bridges and applying the supply voltage, the vac-
uum pump starts up immediately.
Pfeiffer Vacuum therefore recommends switching on the voltage supply immediately before
operation.
Operate without control unit
► Provide the current supply.
After applying the operating voltage, the vacuum pump carries out a self-test to check the supply volt-
age.
Operate via the external control
► Connect the remote control via the "remote" 15-pin D-Sub socket.
The control is carried out by means of "PLC level".
Operate with peripheral devices DCU, HPU or PC
1. When handling the Pfeiffer Vacuum display and control unit, observe the respective operating in-
structions:
– "DCU" operating instructions available from the
Download Center .
– "HPU" operating instructions available from the
Download Center .
2. Connect the respective peripheral device to the 15-pin D-Sub socket.
3. Make the desired settings via the RS-485 using the peripheral device.
Operation
40/66